Moderator: GnATTERbox Moderators
CanveyRay wrote:Just come from the shed - finishing off the pump house - yes used masking tape and boy am I pleased with it! (same painting as before).
Steve Bennett wrote:OK, here we go, first snap of the Sidelines point/turnout levers. The small one on the left, is an O scale one from the Roy Link range to give a size comparison, these are about ¾ the size a scale Hudson lever would be.
As you will see, two different types of lever and weights, both sharing the same base. They can be linked to the tie bar of a turnout by a length of wire, so they move with it. It may be possible to operate the turnout with them, not tried it yet, but there is no locking mechanism, so will be most suitable for use with those that have a built in overcentre spring, like Peco.
Somewhat surprisingly, they also look fine with 9mm gauge track, for use in Gnine.
franckcombe wrote:HiDo you know if we can use it with peco switch and spdt with your lever ? I wish to be sure that your lever is enought strong ?
dr5euss wrote:Steve, any chance of a person in the pic next to the Gnine stuff?
Users browsing this forum: No registered users and 7 guests