Moderator: GnATTERbox Moderators
Geeky Gecko wrote: ... I've completed the track laying, or at least the rails. They are soldered to pins pushed into the board.
Geeky Gecko wrote:Gerald, the pins I have used are 15mm long with heads 3.5 mm diameter. I drilled a hole that is a tight fit for the pin, inserted the pin and then soldered the rail to the head of the pin. The height of the rail can be adjusted slightly by pushing the pin in or pulling it out. This is the first time I have tried this.
Geeky Gecko wrote: I have removed the control levers and replaced them with my own. These won't normally be used and will be hidden beneath the road surface, but can be accessed when needed from the sides.
Users browsing this forum: No registered users and 18 guests