Hi guys, been a while (again), since my last post, it even appears my thread about a small coastal railway layout has bee lost/removed its been that long
Anyway, last week I had a week off work with plenty of time free while my daughter has been at school, so i managed to 'plan' with bits of track for two days before settling on a simple trackplan for a terminus station which will be the main access to a pub and beer garden. The pub being modelled on a certain small pub on the CCLR.
Today, I have got the track laid, wired and tested but have run into a small problem - everything works apart the loco refuses point blank to do anything on the switch blades of one point, it just stops.
The problem point is the one on the left. From left to right on the lower line:
Headshunt, split into 2 sections, both sections working OK.
Point, Peco electrofrog.
Connect track to upper line, isolated on one rail from the other point.
Platform Line (lower track), connected with one rail isolated.
All sections work when switched on, its just the blades on that point, I've swapped to the with a different one, still the same.
Anys suggestions as to what the problem is??? (Im sure it will be a simple oversight on my part).
Below are a couple of shots of the loco in the picture in quarter-build stage - inspired by DA1 at the CCLR, a loco I have a soft spot for.