Wired up 3rd module (which is actually module 2) tonight. Tested OK, after replacing faultt speaker connector.
Track not ballasted yet and also needs properly fixing down at ends, but connected up to module 1, which is ballasted (a bit much in places).
First time I have run my Gn15 locos for a couple of years. They are all DCC fitted as I originally intended to run DCC, but found they ran better on non DCC controller at exhibition. Suspect it was more to do with poor connections between modules, so the wire links on APA modules will help.
Found most locos a bit sluggish at first. This is partly due to long time not used, and partly because it sometimes takes longer for DCC fitted locos to start.
My top heavy stuff was a bit wobbly
, and ballast did not help. The best loco was the Bachmann GE70 based one, which is much heavier with lower cetre of gravity. I remember this did most of the work at last exhibition it attended. As a result i have bought another one on eBay, and am watch some others.
Unfortunately time ran out at club, so will have to wait till next year(at least that is only next Wednesday
) to do some more work.
Track condition will have to be something I am more careful with than on my other layouts as it will have to be suitable for locos from other people to run across.